Tester horizontal

This Horizontal Tensile Tester enables to provide Rapid & Efficient determination of Tensile Strength, Stretch (Elongation) & Elongation Percentage, Tensile Energy Absorption (TEA), & Breaking Length (BL) of Paper, Tissue Paper and Board in its Wet or Dry State. it is equipped with an "Auto Sensing & Auto Clamping", High Friction Clamps which prevents Test Pieces from slippage during measurements. The Parameters are set according to the Standards. When the unit switches to the Test Mode through Main Menu, the Test Procedure starts automatically, after Placing the Test Sample. The Equipment is operated through a Key Pad and the Test Results are displayed on the LCD Panel, after rupture of the Test Sample. The unit is provided with Standard Load Cell and the Clamps for Test Width size 15 mm. Extra on Demand: "Sample Preparation Cutter (Sample Size 15 x 300 mm)" "Load Cell of capacity 20 OR 50 Kg f. (200/500 N)" "Standard Calibration Jig with Check Weights" "Thermal Printer to Print the Instant Test Data" Special Dedicated Window Based Software to Interface the Main Unit with Computer & Printer.

This sale is for Fluke Networks wire map adapter. Office ID listed separately for purchase. If you have bought microscanner or planning buy one from us on wire map adapter is included with meter. This is discontinued product but since it is passive connector it should work with newer versions of fluke meters. In case it does not work with your equipment for any reasons you can return and claim full refund. As well you can test continuity of horizontal cabling or identify the Information outlet vis-a-vis outlet on patch panel. If your UTP Cable tester measures length of UTP cable then with this adapter you may be able to measure length of coaxial cable as well. Fluke Microscanner Introduction MICROSCANNER PRO™ is an all-in-one network tester that you can use to verify twisted pair and coaxial cables, measure length and distance to faults via TDR, and identify active networks and hubs. Features • Tests unshielded twisted pair (UTP), shielded twisted pair (SSTP) and coaxial cable • Pinpoints opens, shorts, crossed and split pairs • Measures cable length via TDR • Checks and verifies wiremap • Generates four different tracing tones to help identify users • Identifies active networking hubs, switches, and PCs. Operating Mode MODE Press MODE to select the desired test. The available modes are: • WIREMAP • OFFICE IDENTIFIER • LENGTH • TONER Calibration Mode MODE + ON OFF Turn the MICROSCANNER PRO OFF, then hold the MODE key down while pressing the ON key to start Calibrate mode. Use MICROSCANNER to calibrate cable lengths of more than 50 feet (15 meters) and up to feet (457 meters). Setting the NVP percentage: Once

The item for offer is Fluke Networks Coaxial adapter for use with Fluke networks Microscanner. Set of office ID and wire map adapter is also available with us and is listed on . If you have bought microscanner or planning buy one from us on wire map adapter is included with meter. This is discontinued product but since it is passive connector it should work with newer versions of fluke meters. In case it does not work with your equipment for any reasons you can return and claim full refund. The adapter has UTP of which only two wires are pre-crimped and other side you would notice co-aaxial male. This is perfect adapter to plug into any UTP cable tester to check co-axial cable used for CCTV applications. As well you can test continuity of horizontal cabling or identify the Information outlet vis-a-vis outlet on patch panel. There are