Axial aluminum

This is the Axial 25T Aluminum Servo Horn for Futaba Axial and Savox Servos. FEATURES: Hard anodized aluminum construction Compression mount two screws install on either side of arm and tighten center hole around servo spline YOU WILL RECEIVE: Axial 25T Aluminum Servo Horn with two Socket Head Screws SPECIFICATIONS: Length: mm) from center of servo mounting hole to end of arm jxs ir jxs

This is the Axial 23T Aluminum Servo Horn for KO and JR Servos. FEATURES: Hard anodized aluminum construction Compression mount two screws install on either side of arm and tighten center hole around servo spline YOU WILL RECEIVE: Axial 23T Aluminum Servo Horn with two Socket Head Screws SPECIFICATIONS: length: mm) from center of servo mounting hole to end of armjxs ir jxs

This is the Axial 24T Aluminum Servo Horn for Hitec Servos. FEATURES: Hard anodized aluminum construction Compression mount two screws install on either side of arm and tighten center hole around servo spline YOU WILL RECEIVE: Axial 24T Aluminum Servo Horn with two Socket Head Screws SPECIFICATIONS: Length: mm) from center of servo mounting hole to end of arm jxs ir jxs

ST Racing Concepts CNC Machined Aluminum Threaded Shock Bodies with Spring Collars and O-Rings (2) Black for the Axial Wraith.#STABK

FEATURES: CNC machined Aluminum shock bodies and capsTitanium gray anodized shock bodies and capsLower shock ends includes red anodized aluminum ballsFully threaded for rapid adjustmentDelrin pistons3.5mm thick shock shaftsShaft exits through double O-ring sealsEasy load shock seal assemblyLaser engraved for authenticityFits scale crawlers trucks 1 10 scale EP buggys and Short course trucks (such as Gmade R1 Axial wraith and XR-10 Traxxas E-maxx and 2WD Slash rear)YOU WILL RECEIVE: Titanium gray anodized aluminum shock bodies x 2Titanium gray anodized aluminum shock caps x 2Diaphragms x 2Shock springs x 2All necessary hardware to finish the shocksAssembly instructionsBottle of shock oilSPECIFICATIONS: Length (Mounting hole to hole): 103mmShock Body diameter: 14mmSpring diameter: 19mmSpring length: 68mmFull Shaft Travel Range: 31mm (without Rubber bump stop)Shaft diameter: 3.5mm

FEATURES: CNC machined stainless steel shock bodies and Delrin pistonsSilver finishUpper and lower shock ends includes red anodized aluminum ballsInternal soft and hard type springs8mm thick shock shaftsEasy load shock seal assemblyFits Gmade R1 rock buggy 1 10 scale crawlers trucks (such as Axial SCX-10 Tamiya High-Lift)YOU WILL RECEIVE: Shock bodies x 2Soft and Hard type springs x 2Shock absorber silicone O-ring x 8All necessary hardware to finish the shocksShock GreaseSPECIFICATIONS: length: 90mm (Mounting hole to hole)Full Shaft Travel Range: 20mmShock Body diameter: 12mmShaft diameter: 8mm