JEWELLERY EMBOSSING PATTERN PLATE IN INDIA

This plate will suitable for rolling mill or hammering to produce finely detailed patterns on your nonferrous metal sheet from 22 ga. to 36 ga. Our Pattern Plate Advantage: Made from special grade BRASS Rust free surface for years of life Does not damage Rolling Mill Best Scrap Value after usage Quality Embossing up to 200 uses Usage Instructions: Use a thin 1/16" hard urethane pad   ●   Thicker metal need to be annealed before embossing   ●   Test with copper sheet before use expensive sheet   ●   24 gauge (mm) sheet gives best result   ●   Use maximum 14 gauge (mm) sheet   ●   Clean texture plate & metal sheet before & after every usage   ●   Flex Shaft, Stone Tip, Diamond Bur or a Mizzy wheel used fine detail work   ●   Plate(s) must not interchangeable between Rolling Mill, Hydraulic Press & any other equipment   ●   Plates will begin to curve with each pass through the Rolling Mill, do not try to modify its curved structure, even curved plate will give quality embossing.