DSPIC33EP128GM 604 MICROCHIP MCU CONTROLLER BRAND NEW IN INDIA

DSPIC33EP128GM604 microchip MCU controller brand new warranty 16K RAM & 128K mem + TQFP to DIP Adapter PCB Board Specs Package - 1 MCU + 1 Adapter This is a Double-Side PCB Circuit Board.  A side for pin pitch size 0.8mm,It can be used for most of the TQFP (compatible with 32pin~64pin) to 2.54mm DIP. B side for pin pitch size 0.5mm,It can be used for most of the TQFP (compatible with 32pin~100pin) to 2.54mm DIP. Features Operating Conditions 3.0V to 3.6V, -40°C to +85°C, up to 70 MIPS 3.0V to 3.6V, -40°C to +125°C, up to 60 MIPS  Core: 16-Bit dsPIC33E CPU Code-Efficient (C and Assembly) Architecture Two 40-Bit Wide Accumulators Single-Cycle (MAC/MPY) with Dual Data Fetch Single-Cycle Mixed-Sign MUL plus Hardware Divide 32-Bit Multiply Support  High-Speed PWM Up to 12 PWM Outputs (six generators) Primary Master Time Base Inputs allow Time Base Synchronization from Internal/External Sources Dead Time for Rising and Falling Edges 7.14 ns PWM Resolution PWM Support for:  DC/DC, AC/DC, Inverters, PFC, Lighting BLDC, PMSM, ACIM, SRM Programmable Fault Inputs Flexible Trigger Configurations for ADC Conversions Supports PWM Lock, PWM Output Chopping and Dynamic Phase Shifting  Advanced Analog Features Two Independent ADC modules: Configurable as 10-bit, 1.1 Msps with four S&H or 12-bit, 500 ksps with one S&H or 49 analog inputs Flexible and Independent ADC Trigger Sources Up to Four Op Amp/Comparators with Direct Connection to the ADC module: Additional dedicated comparator Programmable references with 32 voltage points Programmable blanking and filtering Charge Time Measurement Unit (CTMU): Supports mTouch™ capacitive touch sensing Provides high-resolution time measurement (1 ns) On-chip temperature measurement  Timers/Output Compare/Input Capture 21 General Purpose Timers: Nine 16-bit and up to four 32-bit timers/counters Eight output capture modules configurable as timers/counters PTG module with two configurable timers/counters Two 32-bit Quadrature Encoder Interface (QEI) modules configurable as a timer/counter Eight Input Capture modules Peripheral Pin Select (PPS) to allow Function Remap Peripheral Trigger Generator (PTG) for Scheduling Complex Sequences  Communication Interfaces Four Enhanced Addressable UART modules (17.5 Mbps): With support for LIN/J protocols and IrDA® Three 3-Wire/4-Wire SPI modules (15 Mbps) 25 Mbps Data Rate for Dedicated SPI module (with no PPS) Two I2C™ modules (up to 1 Mbps) with SMBus Support Two CAN modules (1 Mbps) CAN 2.0B Support Programmable Cyclic Redundancy Check (CRC) Codec Interface module (DCI) with I2S Support  Direct Memory Access (DMA) 4-Channel DMA with User-Selectable Priority Arbitration Peripherals Supported by the DMA Controller include: UART, SPI, ADC, CAN and input capture Output compare and timers