FLUKE NETWORKS WIRE MAP ADAPTER UTP I/O INFORMATION IN INDIA

This sale is for Fluke Networks wire map adapter. Office ID listed separately for purchase. If you have bought microscanner or planning buy one from us on wire map adapter is included with meter. This is discontinued product but since it is passive connector it should work with newer versions of fluke meters. In case it does not work with your equipment for any reasons you can return and claim full refund. As well you can test continuity of horizontal cabling or identify the Information outlet vis-a-vis outlet on patch panel. If your UTP Cable tester measures length of UTP cable then with this adapter you may be able to measure length of coaxial cable as well. Fluke Microscanner Introduction MICROSCANNER PRO™ is an all-in-one network tester that you can use to verify twisted pair and coaxial cables, measure length and distance to faults via TDR, and identify active networks and hubs. Features • Tests unshielded twisted pair (UTP), shielded twisted pair (SSTP) and coaxial cable • Pinpoints opens, shorts, crossed and split pairs • Measures cable length via TDR • Checks and verifies wiremap • Generates four different tracing tones to help identify users • Identifies active networking hubs, switches, and PCs. Operating Mode MODE Press MODE to select the desired test. The available modes are: • WIREMAP • OFFICE IDENTIFIER • LENGTH • TONER Calibration Mode MODE + ON OFF Turn the MICROSCANNER PRO OFF, then hold the MODE key down while pressing the ON key to start Calibrate mode. Use MICROSCANNER to calibrate cable lengths of more than 50 feet (15 meters) and up to feet (457 meters). Setting the NVP percentage: Once