HOBBYKING KK2.1.5 MULTIROTOR LCD FLIGHT CONTROL BOARD IN INDIA

Chips-N-Boards Buy Electronics,Robotics,Ardunio,stuff sellar     Other Items Feedbacks About Us Contact Us Add To Favorites CNB700-Aeromodelling QuadCopter MultiRotor Flight Controller Board KK2.0 36x36mm ** Please Do not buy Without Proper Knowledge of What this Board is about and its working and Usage If your new to multi-rotor flight or have been unsure about how to setup a KK board then the KK2.0 was built for you. The 6 Pin USBasp AVR Programming interface ensures future software updates will be quick and easy. Specs. Size:  50.5mm x 50.5mm x 12mm Weight:  21 gram (Inc Piezo buzzer) IC:  Atmega324 PA Gyro:  InvenSense Inc. Accelerometer:  Anologue Devices Inc. Auto-level:  Yes Input Voltage:  4.8-6.0V AVR interface:  standard 6 pin. Signal from Receiver:  1520us (5 channels) Signal to  ESC:  1520us Pre-installed firmware. Dualcopter Tricopter Y6 Quadcopter + Quadcopter X Hexcopter + Hexcopter X Octocopter + Octocopter X X8 + X8 X H8 H6 V8 V6 Aero 1S Aileron Aero 2S Aileron Flying Wing Singlecopter 2M 2S Singlecopter 1M 4S (Custom Mix via the "Mixer Editor" option) The Mixer Editor allows you to adjust where and how much signal the motors receive from stick input and sensors. This allows you to create any configuration possible with up to 8 motors or servos. The HobbyKing KK2.0 Multi-Rotor controller is a flight control board for multi-rotor Aircraft (Tricopters, Quadcopters, Hexcopters etc). Its purpose is to stabilize the aircraft during flight. To do this it takes the signal from the three on board gyros (roll, pitch and yaw) then passes the signal to the Atmega324PA IC. The Atmega324PA IC unit then processes these signals according the users selected firmware and passes control signals to the installed Electronic Speed Controllers (ESC s). These signals instruct the  ESC s to make fine adjustments to the motors rotational speed which