MULTIWII AIO PRO V2.0 FLIGHT CONTROLLER IN INDIA

before placing the order call me Features: - Supported MegaPirateNG and MultiWii firmware - Up to 8-axis motor output - 8 input channels for standard receiver - 4 serial ports for debug/Bluetooth Module/OSD/GPS/telemetry - 2 servos output for PITCH and ROLL gimbal system - A servos output to trigger a camera button - 8 Analog port for Airspeed Sensor/Current & Voltage Sensor/LED controller - User-defined pads D & PG1~PG5 - A I2C port for extend sensor or device - Separate 3.3V and 5V LDO voltage regulator - Onboard 16Mbit Dataflash chip for automatic datalogging - ATMega AU Microcontroller - MPU axis gyro/accel with Motion Processing Unit - HMCL 3-axis digital magnetometer - MSBA01 highprecision altimeter - FT232RQ USB-UART chip and Micro USB receptacle - PCADP1 logic level converter for I2C Match the standard of RoHS Flight modes for Multiwii One of the following basic mode - Acro - Level - Alt Hold - Head Lock - Optional mode - HeadFree (CareFree) - GPS Hold (Need GPS receiver or Extend Board) - GPS Back to home position (Need GPS receiver or Extend Board) Flight mode for MegaPirate - Acro - Alt Hold - Simple - Loiter (uses GPS) - Guided (uses GPS) - Position (uses GPS) - Circle (uses GPS) - RTL (uses GPS) - Auto(uses GPS) - Follow Me(uses GPS) Input power selection One of the following way - Connect 5V power cable from ESC or UBEC to the ESC/Servo port, the J1 jumper must be closed. - Connect 5V~12V power cable to the extend power port, the J1 jumper must be removed. When using Extend Board, AIO PRO must be powered from the extend power port. General Dimension: 50mmX50mm Height: 11.6mm Weight: 14.2g Fixing hole spacing: 45mm Hole diameter: 3mm Package content ALL IN ONE PRO Flight Controller x 1 3Pin to 1Pinx3 cable 100mm x 3 3Pin to 3Pin cable 100mm x 1 Molex 1.25mm 4Pin cable 100mm x1 Molex 1.25mm 6Pin cable 100mm x1 Molex 1.25mm 8Pin cable 100mm x2