WATER LEVEL CONTROLLER FOR SINGLE PHASE SUBMERSIBLE/MO IN INDIA

Fully Automatic Water Level Controller For Single Phase Motors Very Easy to Install High Quality Ships with Installation Diagram Wires and the Terminals on the controller are labelled as per connection diagram to avoid confusion. SMPS Based Design (No heating and failure of Transformers) No Display only one LED - Install and Forget about the Water tank and Pump.. Low Wiring Cost - Only 3 core wire from Tank Can be used for single phase submersible and motors. Features 1) Switch-less Sensing Elements. 2) Sump Sensing. (Don’t Let the motor run if sump is empty). - In case of Bore no sump is present then sump sensing can be bypassed. If no sump sensing required It can be bypassed by connecting a loop to common. 3) Auto and Manual Toggle Switch with LED indication. 4) Motor status indicator 5) Very Low Power Consumption (Technical Specification: 1) Single Phase 230v supply. 2) Up to 5 HP single phase motor can be used. Requirements: 1) Three Core wire to sense overhead tank status. Length - As per Building (Approx 100 Feet for Duplex Houses) Three core cable Costs Approx 3/- Per feet 2) 2 Core Wire to sense Sump Status Costs Approx 2/- Per Feet. *It is also possible to install the controller near the tank and extend the motor wires. Ships With: 1) Ten Feet Wires with Sensing Elements as shown